VAPORIZATION THROUGH EVAPORATORS

For vaporization, it is necessary to use dispensers (up to 200 ml) made of talc magnesite. The dispensers have calibrated openings for water supply and are located on the upper evaporators.  Special rough processing of talc stone helps to actively absorb water from the dispensers onto the evaporators.

 

     The volume of water from the dispenser is controlled by the location of the dispenser. If the dispenser is mounted on a flat surface of the evaporator, the volume of supplied water will be minimal and determined only by the degree of surface roughness. If the dispenser hole is aligned with the evaporator groove, the volume of supplied water increases.

     Water boils 5-7 mm deep in the layered structure of talc stone heated to 350-400 °C and comes out as fine superheated steam. The remaining water flows through special channels to the lower and front evaporators for final evaporation.

   For each upper evaporator, it is optimal to mount 2-3 dispensers, changing the volume of supplied water by the dispensers, you can also change steam from dry to wet. 

IR RAYS

    Due to radiant energy from the stone ANNIKKI electric sauna heater heated to 350 °C, it is enough to heat the air in the sauna only to 70 °C (in summer the best temperature is 40-50 °C, in winter 60-70 °C). Yet, ANNIKKI electric sauna heater can raise the temperature in the steam room to 110 °C and above.

    If necessary (volume of the steam room exceeds 9 m3), it is possible to mount two or more ANNIKKI electric sauna heaters in the steam room.

    The more ANNIKKI electric sauna heaters in the steam room, the better therapeutic effect of IR rays. The wall mounted versions of ANNIKKI electric sauna heaters are especially useful in places where a person sits and relaxes. To boost the IR effects, mount ANNIKKI electric sauna heaters on special stands, including those of different heights.

 

 

 

LAYOUT OF TWO ANNIKKI ELECTRIC SAUNA HEATERS IN THE STEAM ROOM OF THE SAUNA